latapoxy 310spot bonding agent

Price 1280.0 INR/ Kilograms

Get a Price/Quote

MOQ : 1 Kilograms

91 000 74051 Its a two-component, high-strength epoxy adhesive / chemical anchoring bonding not a simple cement-tile adhesive.
Its designed for spot bonding meaning you use dab/spots of this adhesive on the back of marble / stone / tile pieces, then press them onto vertical or overhead surfaces (walls, facades, etc.).
Its especially used for natural stone, marble, granite, heavy tiles, large-format ceramic/slate work anything where a strong, permanent, non-sag bond is required.

Key Features & Advantages

Strong permanent bond once cured, the bond is very durable.
Fast set time standard version sets in ~4560 minutes.
Non-sag consistency you can apply it on walls/vertical surfaces (even overhead), and it wont drip or run.
Non-staining safe for light-coloured stones, tiles, marble, so it doesnt leave visible adhesive marks.
Resistant to shock, vibration, moisture, damp surfaces good for exposed facades, external walls, or areas subject to stress. No mechanical anchors/clamps required simplifies installation compared to mechanical fixing or continuous bedding adhesives.

Where & When Its Generally Used

Suitable for:

Bonding marble, granite, natural stone slabs, large-format ceramic tiles on walls, facades, vertical surfaces, and overheads (e.g. cladding walls, exterior finishes). Fixing heavy stone/veneer slabs in places like stair risers, elevator lobbies, fireplace surrounds, exterior facades anywhere regular thin-set adhesive might fail.
Situations needing strong structural bonding rather than just surface-level tile adhesion (especially with heavy or large stones).

How to Use It (Basics)

It comes in two parts (Part A + Part B). Mix in 1:1 ratio by volume until uniform.
Apply spot-dabs on the back of stone/tile (not full bed), then press onto prepared, clean surfaces (concrete, masonry, cement-backer board, steel, plywood, etc.).
Good for vertical or overhead due to non-sag property and suitable even for exterior or damp surfaces (provided substrate is prepared properly).