Weber Set Firm Tile Adhesive

About Weber Set Firm Tile Adhesive

• It is ready to mix; a single component product.
• It has excellent adhesion properties, no slip is observed on vertical applications.
• Shrinkage cracks are minimized/eliminated due to its self-curing properties.
• Larger quantity of material can be mixed at a time due to its longer pot life.
• It is recommended for windows and door frames.

• It is recommended for application on cementitious substrates, self-levelling screeds and fibre cement boards.
• It can also be used for old tiles (porous and non-porous) on walls using Weber.tec prime and renders for both interior and exterior surfaces.
• Can be used for wet and dry service condition including swimming pools.

• Clean the substrate of oil stains and bond inhibiting compounds. Also remove dirt, dust and laitance if any using high-pressure water jet or any other suitable method.
• Ensure that the substrate is flat, stable, well adhered and has a normal absorption.
• Concrete screeds render and block work should be cured sufficiently to avoid the shrinkage cracks.
• Correct the local undulation/damage on the substrate at least 48 hours before the application of Weber.set firm.
• Saturate the surface well and remove excess water before application of the tile adhesive.

• Gradually add 2.5 parts of powder to 1 part of water (by volume) and mix it to a smooth, workable paste using a suitable stirrer or a low-speed drill mix.
• Do not attempt to extend the pot life by adding more water to the mix.
• After mixing allow the mixture to stand for 2 minutes for it to mature.

• Apply weber.set firm over the surface using the straight edge of the notched trowel and then comb the applied adhesive on the notched side of the trowel to achieve the desired thickness. If the adhesive is buttered to the tile, then ensure proper coverage of the tiled surface to evade voids.
• Firmly press the tile into the adhesive to ensure good initial bonding.