Myk Laticrete Latapoxy 310 Spot Bonding Tile Adhesive

About Myk Laticrete Latapoxy 310 Spot Bonding Tile Adhesive

•  91 000 74051 Its a two-component, high-strength epoxy adhesive / chemical anchoring bonding  not a simple cement-tile adhesive. 

• Its designed for spot bonding  meaning you use dab/spots of this adhesive on the back of marble / stone / tile pieces, then press them onto vertical or overhead surfaces (walls, facades, etc.).

• Its especially used for natural stone, marble, granite, heavy tiles, large-format ceramic/slate work  anything where a strong, permanent, non-sag bond is required. 

• Strong permanent bond  once cured, the bond is very durable. 

• Fast set time  standard version sets in ~4560 minutes. 

• Non-sag consistency  you can apply it on walls/vertical surfaces (even overhead), and it wont drip or run. 

• Non-staining  safe for light-coloured stones, tiles, marble, so it doesnt leave visible adhesive marks. 

• Resistant to shock, vibration, moisture, damp surfaces  good for exposed facades, external walls, or areas subject to stress. No mechanical anchors/clamps required  simplifies installation compared to mechanical fixing or continuous bedding adhesives. 

Suitable for:

• Bonding marble, granite, natural stone slabs, large-format ceramic tiles on walls, facades, vertical surfaces, and overheads (e.g. cladding walls, exterior finishes). Fixing heavy stone/veneer slabs in places like stair risers, elevator lobbies, fireplace surrounds, exterior facades  anywhere regular thin-set adhesive might fail. 

• Situations needing strong structural bonding rather than just surface-level tile adhesion (especially with heavy or large stones).

• It comes in two parts (Part A + Part B). Mix in 1:1 ratio by volume until uniform.

• Apply spot-dabs on the back of stone/tile (not full bed), then press onto prepared, clean surfaces (concrete, masonry, cement-backer board, steel, plywood, etc.). 

• Good for vertical or overhead due to non-sag property and suitable even for exterior or damp surfaces (provided substrate is prepared properly).